Solar Panel & Battery Installation in Bracknell

Solar panels and upgraded leisure batteries are among the fastest-growing upgrades in the touring world, driven by the popularity of off-grid and "wild" pitching and the move to power-hungry devices. A well-designed system keeps the leisure battery charged from sunlight, letting you stay off hook-up for longer.

What's included

A solar and battery installation typically covers:

• Solar panels — roof-mounted rigid or semi-flexible panels, sealed and wired through a roof gland.
• Charge controller — an MPPT (or PWM) controller that regulates charge from the panels to the battery safely and efficiently.
• Battery upgrade — often a move from lead-acid to lithium (LiFePO₄) for greater usable capacity and lifespan, with associated wiring and protection.
• Monitoring — a battery monitor or display so you can see state of charge.
• Integration — safe connection into the existing 12V system, fusing and isolation.

Typical cost

A basic solar install might start around £300, while a comprehensive system with a large panel, MPPT controller and a lithium battery can reach £1,000–£1,500 or more. Lithium batteries are the largest single cost.

Frequency

A one-off installation, though batteries have a finite life (lithium considerably longer than lead-acid) and the system benefits from periodic checks.

Why it matters

Beyond the freedom of off-grid touring, a properly installed system protects your battery from damage and your vehicle from electrical faults. Solar also keeps a battery healthy during storage by offsetting natural drain. Crucially, lithium batteries and higher-current systems must be correctly specified, fused and installed — done wrong, they are a fire risk.

DIY vs professional

Enthusiasts do tackle solar installs, but roof penetrations (a damp risk), correct fusing, lithium battery integration and safe wiring are areas where professional installation pays off — both for safety and for warranty and insurance validity.

What to expect

Installation usually takes most of a day. The engineer will seal the roof penetration carefully (this is where DIY installs most often cause later damp), configure the charge controller, and show you how to monitor the system. Find an installer in your area and request quotes.